DBA 05-09 Subaru Legacy i/Limited Rear En-Shield Standard Rotor DBA2661E

I/Limited Rear En-Shield Standard Rotor by DBA, made to fit the 2005–2009 Subaru Legacy as listed below. Brakes turn speed into heat. Pads, rotors and calipers work together, so their condition matters as a set.

Key features

• Rear position

Specifications

• Brand: DBA
• Part type: Brake part
• Position: Rear

Fitment for the 2005–2009 Subaru Legacy

Listed for the 2005–2009 Subaru Legacy, rear position. Check your year, model and trim against the title before you order.

What it does

Brake parts are usually replaced per axle, left and right together, so the car stops straight. Brakes are the most important safety system on the car; replacing worn parts restores stopping power and pedal feel, and upgraded parts handle heat better.

Installation & tips

• Bed in new pads and rotors following the brand instructions, and bleed the brakes if the system was opened.
• Brake fluid: Old fluid absorbs water; flush it when you do a brake job.
• Hardware: Clips and pins wear with the pads.
• This part affects how the vehicle stops, steers or holds the road. If you are not sure how to fit it, have it installed or checked by a qualified mechanic.

FAQ

Which side or position does it fit?
It is listed for the rear position. If you are replacing both sides, check whether you need one of each.

Can I install it myself?
Many owners do this job at home with the right tools and a service manual, but because it is a safety-related part, have the work checked by a qualified mechanic if you are not sure.

What should I check before ordering?
Compare the part number, specifications and fitment on this page with your vehicle and with the part you are replacing.

Before you order

• Confirm your year, make, model and trim match the fitment listed above (2005–2009 Subaru Legacy).
• Check the position: this part is listed as rear.
• Plan to bleed the brakes and bed in new pads and rotors after fitting, if the job calls for it.